User`s guide

Chapter 4. 1-Channel RAID Controller Installation
EK–SWRA2-IG. C01 4–11
4.2.2.4 Labeling the Installed Drives
Label the disk drives that are installed in the Expansion Storage Pedestal to
identify their Device Type, Channel, and SCSI ID (for example, Dev: RZ26L,
CH: 0, ID: 1).
NOTE
The SCSI ID is determined by the slot number in
the Expansion Storage Pedestal, as shown in
Figure 4-11.
To support the Expansion Storage Pedestal’s hot swap option, check the label on
the power supply SBB to ensure it is BA35X-HA Rev. L01 or later.
Figure 4–11 Device Labels