User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
4–10 EK–SWRA2–IG. C01
4.2.2.3 Cable Installation — Method 3
1. Open the front and rear bezel doors and remove both bezels from the pedestal
by pressing down on the locking tabs at the bottom of each bezel.
2. Remove the filler panel on the front bezel that is closest to the host computer
(see Figure 4-8).
3. Connect the cable to connector JA1 (upper-left connector when viewed from
the front) on the internal side of the backplane (see Figure 4-10).
4. Replace the bezels ensuring that the locking tabs snap into place at the bottom
of each bezel.
5. Insert the other end of the SCSI cable into the connector for the RAID
controller connector (External Channel 0) at the back of the host system.
Figure 4–10 Routing the SCSI Cable — Method 3