User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
4–8 EK–SWRA2–IG. C01
Figure 4–7 Routing the SCSI Cable — Method 1
4.2.2.2 Cable Installation - Method 2
1. Open the front and rear bezel doors and remove both bezels from the pedestal
by pressing down on the locking tabs at the bottom of each bezel.
2. Remove a filler panel on the rear bezel that is closest to the host computer
(see Figure 4-8).
3. Loop the cable below the divider plate and connect the cable to connector
JA1 (upper-left connector when viewed from the front) on the internal side of
the backplane (see Figure 4-9).
4. Replace the bezels ensuring that the locking tabs snap into place at the bottom
of each bezel.
5. Insert the other end of the SCSI cable into the connector for the RAID
controller (External Channel 0) at the back of the host system.