User`s guide

Chapter 3. Updating EISA Information
EK–SWRA2–IG. C01 3–15
Figure 3–13 The Reboot After Changing the ECU Screen
EISA Configuration Utility Help=F1
Your configuration file has been saved, and if possible a
backup SYSTEM.SCI file has been made on the current drive.
To complete your configuration, you must do one of the
following:
If you need to install boards or change switches and
jumpers on boards already installed, turn off your computer
and do so.
If you want to test your system or install an operating
system, press ENTER to restart your computer, run the
configuration utility again, and select the appropriate
main menu item.
If you are finished configuring, remove the SYSTEM
CONFIGURATION diskette if it is in drive A and press ENTER
to restart your computer.
7. Follow the directions on your screen to save and exit the ECU.
8. Remove the diskette and turn off the power to the host system, then turn on
the power to the host system.
Now that you've updated the ECU, go on to Chapter 4 to install a 1-channel
controller, or Chapter 5 to install a 3-channel controller.
Refer to the Roadmap, Table 2–1, for an overview of the complete installation
process.