User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
3–12 EK–SWRA2–IG. C01
2. Intel systems boot from the adapter board with the lowest BIOS address. If
your system boots off an EISA adapter board, then you need to view the
BIOS address of all the controllers installed in your system to make sure that
the adapter from which you boot has the lowest BIOS address.
3. If your system already has more than one board installed, the ECU should
assign a different interrupt to the new board you are installing. However, you
can change the interrupt if you need to. Before you select an interrupt
option, consult your system and operating system documentation to ensure
that your system supports interrupts.
You can use the following interrupts to configure the RAID controller:
NOTE
OpenVMS for AXP systems and DEC OSF/1
support Edge Interrupts only
11 Level
11 Edge
12 Level
12 Edge
14 Level
14 Edge
15 Level
15 Edge
(Do not use Interrupt 15 for Novell NetWare. If the ECU assigns 15 to
the RAID controller and you plan to use Novell NetWare, you will
need to change the interrupt level.)
4. Press the F10 key when you finish setting these parameters. The Steps in
configuring your computer appears similar to Figure 3–11.