User`s guide

Chapter 3. Updating EISA Information
EK–SWRA2–IG. C01 3–11
3.2.3 Setting BIOS Address and Interrupt
The .CFG file that you copied during the Add or remove boards procedure sets
the BIOS and Interrupt parameters with default values. You may need to change
these settings as described in Steps 2 and 3.
NOTE
The Add or remove boards procedure sets the
BIOS for Intel-based systems only; Alpha systems
do not use the BIOS
1. Select the View or edit details option Step 3 in the sample screen shown in
Figure 3–9 and press the Enter key. Scroll through the file until you find the
slot number for the controller you are installing. The information for a
1-channel board appears similar to Figure 3–10. If installing a RAID
controller in an Alpha system, go on to Step 3.
Figure 3–10 ECU Details for a 1-Channel Controller
BIOS (16K) Base Address 0CC000H - Default
Interrupt Interrupt 11 (edge) - Default
Edit=ENTER <Edit Resources=F6> <Advanced=F7>
<Done=F10>
The display for a 3-channel board installation differs slightly.