User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
3–4 EK–SWRA2–IG. C01
Figure 3–2 The Add or Remove Board Screen
Step 2: Add or remove boardsHelp=F1
Listed are the boards and options detected in your
computer.
♦ To add boards or options which could not be
detected, or which you plan to install, press
Insert key.
♦ To move the highlighted board to another slot,
press the F7 key.
♦ To remove the highlighted board from the
configuration, press the Del key.
When you have completed this step, press the F10 key.
Slot 1(Empty)
Slot 2(Empty)
Slot 3(Empty)
Slot 4(Empty)
Slot 5(Empty)
Slot 6(Empty)
Add=INSERT <Remove=DEL> <Move=F7> <Done=F10>
• To install an SWXCR-EA 1-channel controller, you need one
empty EISA slot.
• To install an SWXCR-EB 3-channel controller, you need two
empty EISA slots in close proximity, for cabling purposes,
during the hardware installation. (If your system has additional
punchout slots to accommodate SCSI channels, you need only
one EISA slot).