User`s guide
StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
iv EX-SWRA2-IG. C01
2 Preparing to Install
2.1 Installation Overview ..............................................................................................2-1
2.2 Preparing to Install ..................................................................................................2-3
2.2.1 Verifying User Supplied Hardware and Software (System Requirements)..........2-4
2.2.2 Verifying the Controller Kit and Storage Enclosures..........................................2-5
2.2.2.1 The Controller Kit .............................................................................................2-5
2.2.2.2 The Storage Enclosure.......................................................................................2-5
2.2.3 Verifying the Cables Required for your Subsystem Configuration .....................2-6
2.2.4 Backing up Your System ...................................................................................2-6
3 Updating EISA Information
3.1 Updating EISA Information.....................................................................................3-1
3.2 Running the ECU.....................................................................................................3-2
3.2.1 Starting the ECU ...............................................................................................3-2
3.2.2 Adding a New Board to the ECU .......................................................................3-3
3.2.3 Setting BIOS Address and Interrupt.................................................................3-11
4 1-Channel RAID Controller Installation
4.1 Installing the 1-Channel RAID Controller Board .....................................................4-1
4.2 Cabling....................................................................................................................4-3
4.2.1 Shelf_OK Jumper Installation and Verification..................................................4-4
4.2.2 SCSI Cable Installation......................................................................................4-6
4.2.2.1 Cable Installation - Method 1 ............................................................................4-7
4.2.2.2 Cable Installation - Method 2 ............................................................................4-8
4.2.2.3 Cable Installation - Method 3 ..........................................................................4-10
4.2.2.4 Labeling the Installed Drives...........................................................................4-11
4.2.3 Power Cable Installation..................................................................................4-12