User`s guide

EK–SWRA2–IG. C01 3–1

Updating EISA Information

This chapter describes the procedures required for updating EISA Configuration information on

computer systems into which you install an EISA RAID controller. The procedures require you to

run the EISA configuration (or system configuration) utility.

3.1 Updating EISA Information

You need to run the EISA Configuration Utility (ECU) to update the

configuration information stored on nonvolatile memory in your system

whenever you add or remove EISA controllers. The system BIOS uses the

contents of the EISA nonvolatile memory during boot to initialize EISA

controllers installed in your computer.