User`s guide

Index
EK–SWRA2–IG. C01 Index–3
E
ECU, see EISA configuration utility
edge, 3–12
EEPROM
swapping between controllers, 8–27
EISA
updating EISA information, 3–1
slots, 3–3, 3–4, 3–8
EISA configuration utility (ECU)
adding a new board, 3–3
running, 3–2
setting BIOS address and interrupt, 3–11
starting, 3–2
error messages, 8–13
F
failed, 7–11
fault management, 6–6, 6–12
FLD, 7–11
FMT, 7–11
format, 7–11
firmware
determining version, 6–6
updating on an Intel-system, 9–3
updating on an AXP system, 9–6
H
hardware
user-supplied, 2–5
hot spare
defined, 1–9
defining, 6–43, 7–33
display, 7–11
use, 6–16
hot swapping
defined, 1–9
use, 6–16, 7–54
HSP, 7–11
I
initializing a logical RAID drive, 6–23
installing
1-channel RAID controller, EISA, 2–2,
4–1
1-channel RAID controller, PCI, 2–2,
4–1
3-channel RAID controller, EISA, 2–2,
5–1
3-channel RAID controller, PCI, 2–2,
5–1
preparing to, 2–3
power cable, 4–12, 5–19
installation overview, 2–1
interrupts, 3–12
level, 3–12
edge, 3–12
J
JBOD, 1–7, 6–20, 6–21
jumper installation, 4–4, 5–8
L
LEDs
pedestal status, 8–1
power supply, 8–1
Drive SBB status, 8–4