User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
9–34 EK–SWRA2–IG. C01
To update multiple controllers with a single version of the BIOS, type:
A:\SWXCR>SWXCRBIO -v xxx
where xxx is the version of the BIOS, 215 for example
To update multiple controllers with multiple versions of the BIOS, type:
A:\SWXCR>SWXCRBIO xxxx.xxx xxxx.xxx
where xxxx.xxx xxxx.xxx are the BIOS filenames and versions of the BIOS
that you want to load, SWXCRBIO.xxx SWXCRBIO.xxx, for example.
When updating multiple versions of the BIOS to multiple controllers, you
must specify:
• The BIOS filename and version extension as many times as you have
controllers that you want to update
• The BIOS filenames in the slot order in which the controllers were
installed
Thus if you have controllers in slots 1 and 2 for which you want to load a
BIOS version xxx, and xxx; and a controller in slot 3 for which you want to
load a BIOS version xxx, you would type, for example: SWXCRBIO.xxx
SWXCRBIO.xxx SWXCRBIO.xxx
After you enter either form of the command, the system displays messages
similar to the following:
SWXCR BIOS Write Utility Ver. 1.0 - January 4,
1993
Mylex Corporation
Writing EEPROM ...
Verifying EEPROM ...
SWXCR BIOS Write Completed
3. Press any key to reboot the system.
If you were directed to update BIOS in Chapter 4, return to Section 4.2.3, step 7.
If you were directed to update BIOS in Chapter 5, return to Section 5.2.3, step 7.