User`s guide

Chapter 9. Upgrading
EK–SWRA2–IG. C01 9–29
1. Use the arrow keys to highlight the Data Parameters option on the Edit/View
Parameters menu and press the Enter key. The Physical Parameters screen
appears, similar to the one shown in Figure 9–20, with the Default rebuild
rate option highlighted.
Figure 9–20 The Physical Parameters Screen
2. Press the Enter key and a box appears at the bottom right corner of the screen
in which you can type a rebuild rate from 0–50. The default rebuild rate, 50,
is the fastest rate at which the system will rebuild data from a failed drive.
You can not change the rebuild rate for a rebuild in progress.