User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
9–28 EK–SWRA2–IG. C01
9.4.2 Setting Controller Parameters
Previously, to set parameters, such as for EISA controllers you needed to use the
EISA Configuration Utility (ECU). Presently, you use the Standalone
Configuration Utility to set these parameters for both EISA and PCI controllers.
To access the controller parameters, use the up and down arrow keys to highlight
the Controller Setup option on the main menu and press the Enter key to select
it. The Edit/View Parameters menu appears as shown in Figure 9–19.
Figure 9–19 The Edit/View Parameters Menu
9.4.2.1 Completing the Controller Parameters
To set the Controller Parameters, follow these steps.