User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
9–26 EK–SWRA2–IG. C01
9.4.1.1 Invoking the Standalone Utility on Intel Systems
To invoke the standalone utility on an Intel (486 and up) system, follow these
steps:
1. Insert the RAID Array 200 Standalone Configuration Utility for Intel
Systems diskette in your floppy drive.
2. Start or reboot your computer, leaving the diskette in the floppy drive. Your
computer boots from the RAID Array 200 Standalone Configuration Utility
V3.0 for Intel Systems diskette rather than your hard disk.
3. Type: A:\SWXCR> swxcrmgr
The utility checks the drives, and then displays the main menu as shown in
Figure 9–17.
Figure 9–17 The Main Menu of the Standalone Utility
Section 9.4.3 describes how to exit from the utility.