User`s guide

Chapter 9. Upgrading
EK–SWRA2–IG. C01 9–25
Figure 9–16 The Reboot After Changing the ECU Screen
EISA Configuration Utility Help=F1
Your configuration file has been saved, and if possible a
backup SYSTEM.SCI file has been made on the current drive.
To complete your configuration, you must do one of the
following:
If you need to install boards or change switches and
jumpers on boards already installed, turn off your computer
and do so.
If you want to test your system or install an operating
system, press ENTER to restart your computer, run the
configuration utility again, and select the appropriate
main menu item.
If you are finished configuring, remove the SYSTEM
CONFIGURATION diskette if it is in drive A and press ENTER
to restart your computer.
8. Follow the directions on your screen to save and exit the ECU.
9. Remove the diskette and turn off the power.
9.4 Setting Controller Parameters
You must set the following after installing your RAID controller
• controller parameters
• Fault Management and Battery Backup options
Invoke the Standalone Configuration utility.
9.4.1 Invoking the Standalone Configuration Utility
The procedure for invoking the standalone configuration utility varies based on
your type of system. See the following system-specific instructions for Intel and
AXP systems.