User`s guide

Chapter 9. Upgrading
EK–SWRA2–IG. C01 9–23
3. Set the BIOS address to the value previously recorded in step 5 of Section
9.3.1.
4. Set the interrupt level to the value previously recorded in step 5 of Section
9.3.1.
5. Press the F10 key when you finish setting these parameters. The Steps in
configuring your computer appears similar to Figure 9–14.
Figure 9–14 The ECU Main Menu
EISA Configuration Utility
Steps in configuring your computer
STEP 1: Important EISA configuration
information
STEP 2: Add or remove boards
STEP 3: View or edit details
STEP 4: Examine required details
STEP 5: Save and exit
Select=ENTER <Cancel=ESC>
6. Select the Save and exit option (Step 5 in this example) and press the Enter
key. A save and exit screen appears similar to Figure 9–15.