User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
9–22 EK–SWRA2–IG. C01
9.3.4 Setting BIOS Address and Interrupt
The .CFG file that you copied during the Add or remove boards procedure sets
the BIOS (for Intel-based systems only; Alpha systems do not use BIOS) and
Interrupt parameters with default values.
You may need to change these settings.
To view and, if necessary, change these settings, follow these steps:
NOTE
Other parameters that you recorded prior to
removing the controller will no longer appear in the
View or edit details file. You must now use the
standalone configuration utility to set these
parameters. Section 9.4 describes how to do this.
1. Select the View or edit details option Step 3 in the sample screen shown in
Figure 9–12 and press the Enter key.
2. Scroll through the file that now appears on your screen until you find the slot
number for the controller you are installing. The information for a
1-channel board appears similar to Figure 9–13. If installing a RAID
controller in an Alpha system, go on to Step 4.
Figure 9–13 ECU Details for a 1-Channel Controller
Slot 5 – Digital SWXCR–EA EISA RAID Controller (1-channel)
BIOS (16K) Base Address 0CC000H -
Default
Interrupt Interrupt 11 (edge) -
Default
Edit=ENTER <Edit Resources=F6> <Advanced=F7>
<Done=F10>
The display for a 3-channel board installation differs slightly.