User`s guide

Chapter 9. Upgrading
EK–SWRA2–IG. C01 9–19
Figure 9–10 The Add Slot Screen
Add
Select an acceptable slot for the board and press ENTER.
Slot 1 (Empty)
Slot 2 (Empty)
Slot 3 (Empty)
Slot 4 (Empty)
Slot 5 (Empty)
Slot 6 (Empty)
The ( ) indicates an acceptable slot for the board
>Ok=Enter< <Cancel=ESC>
6. To install the controller, select the slot it was previously installed in. (This
slot was noted in step 2 of Section 9.3.2.). Press the Enter key. Figure 9–11
shows Slot 6 selected for the installation.