User`s guide

Chapter 9. Upgrading
EK–SWRA2–IG. C01 9–11
Figure 9–2 ECU Details for a 1-Channel Controller
Slot 5 – Digital SWXCR–EA EISA RAID Controller (1-channel)
Disk Spin-up 2 disks every 6 seconds –
Default
Channel 0 tag-queuing (SCSI-2) Enable tag-queuing –
Default
Channel 0 transfer rate (Max) Synchronous, 10 MB/s
(fast) – Default
BIOS (16K) Base Address Disable BIOS
Interrupt Interrupt 11 (edge) -
Default
Edit=ENTER <Edit Resources=F6> <Advanced=F7>
<Done=F10>
5. Record the settings for these parameters on a piece of paper, so that you can
reset the parameters later using the standalone configuration utility.
6. Press the Esc key when you finish recording the parameter settings. The
Steps in configuring your computer screen appears. Follow Section 9.4.3 to
remove the board from the ECU.
9.3.2 Removing the Board From the ECU
To remove the board from the ECU, follow these steps:
1. Choose the Add or remove boards option (Step 2: in the example screen
shown in Figure 9–3), and press the enter key. A screen similar to the one
shown in Figure 9–4 displays, listing the current EISA boards in your
system.