User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
9–8 EK–SWRA2–IG. C01
**********************************************************
******
Hit any key to proceed. . . .
**********************************************************
******
Programming (This could take up to 1 minute.). . . . first
SWXCR controller successfully programmed.
**********************************************************
******
Hit any key to proceed. . . .
**********************************************************
******
PLEASE CYCLE SYSTEM POWER . . . .
5. Start the standalone utility, view the firmware version displayed on the main
menu to verify the update. Then:
• For a PCI controller, or EISA version 2.0 or later, exit the utility and
remove the standalone utility diskette from the floppy drive; this
completes the firmware update. Return to Section 6.3 to set controller
parameters.
• For an EISA controller no greater than version 1.99, go on to Section
9.3 to continue the firmware update process. For versions 2.00 or
greater, remove the standalone utility diskette from the floppy drive.
This completes the firmware update, return to Section 6.3 to set or
check controller parameters and configure the array.