User`s guide

Chapter 9. Upgrading
EK–SWRA2–IG. C01 9–5
**********************************************************
******
PLEASE CYCLE SYSTEM POWER . . . .
3. Start the standalone utility, view the firmware version displayed on the main
menu to verify the update. Then:
• For a PCI controller, exit the utility, and remove the standalone utility
diskette from the floppy drive. This completes the firmware update for
PCI controllers, return to Section 6.3 to set controller parameters.
• For an EISA controller no greater than version 1.99, go on to Section
9.3 to continue the firmware update process. For versions 2.00 or
greater, remove the standalone utility diskette from the floppy drive.
This completes the firmware update, return to Section 6.3 to set or
check controller parameters.