User`s guide

Chapter 8. Troubleshooting and Service Information
EK–SWRA2-IG. C01 8–25
7. Align the replacement blower connector and insert the module straight in,
making sure that both locking tabs are firmly seated in the pedestal.
8. Replace the safety screw in the corner of the blower.
9. Verify that the pedestal and all SBBs are operating properly (refer to pedes-
tal status, Tables 8-1 and 8-2).
10. Replace the rear bezel and ensure the bezel locking tabs snap into place.
NOTE
If the left power supply LED (pedestal status)
does not come on and all the pedestal power
supplies are operating, the second blower may
have failed or the wrong blower was replaced.
Figure 8–4 Removing a Blower