User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
8–20 EK–SWRA2–IG. C01
8.4 Removal and Replacement
This section describes the following:
• Replacing a drive SBB
• Replacing a power supply SBB
• Replacing a blower
• Replace an
RAID controller
8.4.1 Replacing a Drive SBB
CAUTION
Once a device has been configured by the RAID
controller, moving the device to another bus or
changing the device address can cause problems
or loss of data.
Normally, a storage device is replaced when the device fault indicator is on as
defined in Table 8-3. Ensure that you fail the drive and that the drive has spun
down. To remove or replace a storage device, do the following.
CAUTION
Ensure the replacement SBB is the same type as
the one being removed. Also, always use both
hands when handling a device and be careful to
prevent electrostatic discharge damage by not
touching the device connector.
1. Open the door on the front bezel and remove the bezel from the pedestal by
pushing down on the locking tabs at the bottom of the bezel.
2. Press the two locking tabs (see Figure 8-3) to release the drive SBB and re-
move the SBB.
3. Wait at least 20 seconds, then insert the replacement device into the guide
slots and slowly push it in until it is fully seated and the mounting tabs en-
gage the pedestal.
4. Observe the status LEDs on the new device. The green device activity LED
is either on, flashing, or off, and the amber device fault LED is off.
5. Replace the front bezel and ensure the bezel locking tabs snap into place and
close the bezel door.