User`s guide

Chapter 8. Troubleshooting and Service Information
EK–SWRA2-IG. C01 8–19
Figure 8–5 Error Messages (continued)
Error/Problem Probable Cause Action(s) to Take
SWXCR RAM : 4
Mbytes
Device identified for
Chn 0, Tgt 1 found
at Chn 0, Tgt 2
Device identified for
Chn 0, Tgt 2 found
at Chn 0, Tgt 1
Drives were removed
and replaced in the
wrong slot.
• Use the message to identify the
drives that have been misplaced.
• Power off your system and Stor-
ageWorks pedestal or shelves.
• Correct the problem.
• Turn on the storage pedestal(s)
and then the system.
• Verify that no warning messages
appear.
System abend un-
der Novell NetWare
Novell NetWare does
not support the
SWXCR controller at
interrupt 15
For the EISA board, run the ECU
to set the interrupt level to another
value.