User`s guide

Chapter 7. Maintaining the Array with the Standalone Configuration Utility
EK–SWRA2–IG. C01 7–57
If the Rebuild Bad Block Table contains error entries, this indicates some internal
error with one of the drives which the utility used to try to rebuild data. If no
entries appear in the Rebuild Bad Block Table, check for physical problems, such
as whether the drives in the drive group are properly seated, or if a connecting
cable is loose.
Attempt to rebuild the data onto the replacement drive again. If the rebuild fails a
second time, and bad block entries appear in the Rebuild Bad Block Table, you
will need to reconstruct the data from backup media.
Figure 7–33 Bad Block Table Screen