User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
7–4 EK–SWRA2–IG. C01
7.1.2.1.1 Invoking the Utility on an Intel System
To invoke the standalone configuration utility on an Intel System, follow these
steps:
1. Insert the Standalone Configuration utility diskette for Intel Systems in your
floppy drive and boot from that drive.
2. Type the following command at the prompt to invoke the utility:
A:\SWXCR> swxcrmgr
The utility inquires what devices are connected to the adapter and identifies them
by Channel # and Target ID similar to the screen shown in Figure 7–1.
Figure 7–1 Introductory Screen
After inquiring the connected devices, the utility displays the main menu, as
shown in Figure 7–2.