User`s guide

Chapter 7. Maintaining the Array with the Standalone Configuration Utility
EK–SWRA2–IG. C01 7–3
7.1.2 Using the Utility
Use the Standalone utility to configure and maintain your RAID Array 200
Subsystem. Use the standalone utility to initially configure your subsystem and
then to maintain the subsystem by changing the configuration, if necessary, and
to view the status of the logical and physical drives. In addition, use the
standalone utility to rebuild and format the drives as necessary.
7.1.2.1 Invoking the Utility
You can invoke the utility on an Intel system or an AXP system. If you have an
Intel system, refer to Section 7.1.2.1.1, Invoking the Utility on an Intel System.
If you have an AXP system, refer to Section 7.1.2.1.2, Invoking the Utility on an
AXP System.
NOTE
Turn on the power to your storage enclosure,
before turning on the power to your computer and
invoking the utility.
When you invoke the utility, the utility first checks the status of each drive. If the
drive status changes after you invoke the utility (for example, if a drive fails or if
you remove a drive), the utility does not display the change until the next time
you invoke the utility.