User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
6–46 EK–SWRA2–IG. C01
NOTE
If you start your system with the storage
enclosure disconnected, with the storage
enclosure's power turned-off, with different drives
installed in subsystem slots, or with other physical
changes, the system will abort the installation. (An
Intel system will display the following BIOS
message: Installation Aborted. Alpha
systems do not have BIOS.)
The installation aborts, because the configuration
that the controller sees does not match the
configuration stored on the controller's NVRAM.
Reconcile the physical and stored configurations
by returning your storage enclosure to its previous
configuration, or rebooting your system from the
standalone configuration diskette and changing
the configuration stored on the controller.
Now, go to Section 6.6.5 to initialize the logical RAID drive.