Technical data

Technical Specifications
A-18
OCP Messages
During certain failure conditions, including out-of-range conditions, an error message
is displayed on the OCP panel and a corresponding error code sounds from the
server’s speaker.
NOTE:
To disable the speaker, press the middle button
located below the OCP once after a beep sounds. To
enable it, press the button again.
Hot keys are defined in BIOS as [CTRL] + [ALT] +[1] and enable toggling of the OCP
display status messages just as though the OCP button were pressed.
NOTE:
Hot keys do not work during POST or during host
server request service from the OCP.
If you do not press keys or buttons for some time, the LCD back light will be disabled
until you press a key. The time is set by the host server.
You can examine the server status messages by pressing the OCP switch located
on the front panel repeatedly to sequence through the status list. The OCP switch is
disabled during POST, during host request service from the 8031, or if an error is
detected. The following table lists and describes the status messages and the error
messages that appear on the server’s OCP panel. Also included are possible
actions to take if a problem persists. If this action does not alleviate the problem,
contact your authorized service provider.