Technical data

Connecting Storage Devices
9-2
Single Backplane Configuration
To connect SCSI devices to a single SCSI channel, perform the following:
1. Power down the server.
2. Disconnect all peripheral devices from the server.
3. Unlock and remove the server side panels.
4. Connect the cables as shown in Figure 9-1.
5. If using the top 5¼-inch drive bay, connect the appropriate power cable to
the device.
6. Replace and lock the side panels.
7. Connect all external devices and then power on your server.
8. Run the SCSI Configuration Utility to configure your server.
Refer to Chapter 2, “Server Software and Utilities,” and to your SCSI
documentation for additional configuration information.