Technical data

Installing Disk and Tape Drives
7-11
Installing a Full-Height 5¼-Inch Device into the Top-Right Drive
Bay
To install a full-height 5¼-inch device into the top-right drive bay slots, perform the
following:
1. Turn off your server.
2. Disconnect all external devices, ac power, and monitor power.
3. Unlock and remove the side panels.
4. Unlock and open the door.
5. Remove both plastic filler panels by pushing them out from inside the server.
6. Remove the bottom brackets from the inside of the drive bay and attach
them to device.
7. Remove the divider bracket (A, Figure 7-3) from the right side of the drive
bay.
8. Insert the device into the drive bay from the front.
9. Secure the device using the four supplied mounting screws.
10. If applicable, replace the plastic filler panels.