Technical data

Installing Disk and Tape Drives
7-7
Cables
Your server comes with the following cabling arrangements:
•
Two IDE cables

One IDE cable is installed and connected to the factory-
installed CD-ROM drive. The second IDE cable is supplied in the server
accessories kit for installing an optional IDE device.
•
Two wide SCSI cables and terminators

One SCSI cable and terminator
are installed for a single SCSI channel configuration. The second SCSI
cable and terminator are supplied for dual SCSI channel configurations.
•
One jumper cable

The jumper cable is used to connect the two storage
backplane segments together. This cable is installed for a single channel
configuration.
•
External SCSI cable and terminator

The external SCSI cable and
terminator are supplied in the server accessories kit for connecting SCSI
channel 2 on the main logic board to an external storage device. Use the
supplied terminator if no storage device is attached to the SCSI cable.
Refer to Chapter 9, “Connecting Storage Devices,” for cabling diagrams.