Technical data

Upgrade Procedure
7-4
7. Power on the system and run AMI diagnostics to verify the hardware
upgrade.
NOTE: The hardware upgrade is complete.
8. After the hardware installation is completed, the customer may install the
software on the new system.
9. Refer to the operating system manuals, the
Installation Guide
(ER-J2BWW-IM),
or the web page (http://www.windows.digital.com) for driver and operating system
installation.
10. At this time, the customer should call their software service provider to update
their license with the new system serial number. If desired, the customer can
continue to use the old system; in which case, the customer will need to buy a
new software license for the new system.
Troubleshooting Guidelines
If the server does not boot properly after installing upgrade, check the following items:
•
Check all the configuration information that the customer recorded from the
previous system.
•
Verify that all cables are seated properly.
•
Verify that all cards, boards, and modules are seated properly.
•
Check the processor speed settings.
•
Use the Troubleshooting information in Chapter 4 to identify the problem.
•
Create and run diagnostic diskettes by using the Quick Launch CD-ROM. AMI
Diagnostic software contains an advanced set of diagnostic utilities for identifying
and correcting problems when upgrading the server.