Technical data

Upgrade Procedure
7-2
Feature DIGITAL Server 5200 DIGITAL Server 5220 Upgrade
Slots 6 PCI, 5 EISA 9 PCI, 1 PCI/ISA, 1 ISA
USB ports No Yes (2)
DIGITAL RSM Support
(EISA card)
Yes Not available
Certified Operating Systems
Windows NT Server V4.x V4.x/5.x
Novell NetWare V3.x/4.x V4.x only
IBM OS/2 Warp V3.x V4.0
SCO UNIX Open Server V3.2.x V5.0.4, 5.0.4c, 5.0.5
Banyan VINES - V7.0
SCO UNIXWARE V3.x V2.1.2, 7.0
Upgrade Procedure
The following section describes the procedure that should be followed to install the
upgrade.
1. Before the scheduled upgrade, ensure that the customer has backed up the
system and recorded all configuration information.
2. Check the voltage selection switch and plug in the power cord.
CAUTION: Make sure the voltage selection switch on
the back of the new server is set to match the power
source before plugging in the power cord, or you may
damage the server.
3. Install any additional processor. (Refer to Chapter 5, FRU Replacement.)
4. Install memory. The DIGITAL Server 5220 requires at least 64 MB and can
accommodate up to 1 GB of
Registered
SDRAM memory.
NOTE:
You
cannot use ECC/EDO DIMMs installed in a DIGITAL Server 5200.
5. Install any expansion boards. The DIGITAL Server 5220 has PCI and ISA
slots only; EISA cards are not supported.