Technical data

Installing Additional Memory
6-5
Installing DIMMs on the Processor Module
Use the following procedure to install DIMMs:
CAUTION
:
To avoid possible damage to the
components, place the antistatic wrist strap on your wrist
and connect the grounding clip to a non-painted metal
surface of the server’s chassis.
1. Power down your server.
2. Remove the side panel or top cover.
Refer to Chapter 3, “Server Components,” for more information.
3. Remove the processor module.
4. Unpack the DIMMs. Refer to “Memory Configurations” described earlier in
this chapter for information on the supported memory configurations.
5. Install DIMMs starting with the next available Bank on the processor module,
orient the DIMM so that the two notches at the bottom edge of the DIMM are
aligned with the keyed socket (see Figure 6-2).