Technical data

Server Components
3-28
7. Install the new battery/RTC (Figure 3-15). When installing the new battery,
make sure the “+” side faces up.
8. For the DIGITAL Server 3220 only, replace the side panel and then close
and lock the front bezel (see Figure 3-3).
9.
For the DIGITAL Server 3220R only:
a. Replace the top cover (see Figure 3-7).
b. Slide the server into the rack and then secure it using the two
previously removed screws (see Figure 3-4).
c. Connect the cable management arm (see Figure 3-5).
d. Replace the front bezel (see Figure 3-4).
e. Connect any previously removed cables to the rear of the server.
10. Restore power, reboot and then run the BIOS Setup utility to configure your
server.
Refer to Chapter 2, “Server Software and Utilities,” for information on using the
BIOS Setup utility.