Technical data

11-1
11
Connecting SCSI and RAID Devices
11
Introduction
This chapter contains the cabling configurations that must be followed when
connecting SCSI and RAID devices.
Refer to Chapter 7, “SCSI Device Configurations,” for detailed information on
SCSI configuration guidelines.
SCSI Cable Configurations
The following sections describe the available SCSI cable configurations for your
DIGITAL Server.
Wide Ultra SCSI Cable Configuration
To connect wide Ultra SCSI devices, perform the following:
1. Power down the server.
2. Disconnect all peripheral devices from the server.
3. Remove the access panel(s).
4. Connect the cables as shown in Figure 11-1.
Use the nylon cable clamps to dress the cables properly. Do not block the
air flow from the fan.