Owner`s manual

Soon after this message
appears, a module installation
menu appears.
You can return to the Hub Instal-
lation menu anytime by pressing
Ctrl/C on the setup port device.
If the module in the slot you select
does not support redirect mode, the
following message appears:
Line card does not support redirect.
Press Return for Main Menu ...
Refer to your module’s
documentation to
determine if it supports
redirect mode.
3–29Hub Manager
[13] Start Redirect Mode
Start redirect mode allows you to redirect the setup port input and output to the setup
port of a network module that is installed in the hub. This mode lets you configure or
obtain status of the network module in the slot number that you select.
The following is an example of the dialog associated with this option
(user response is shown in boldface type):
Enter selection : 13
Enter the slot number for redirection (1–8) : 3
Return
Console redirected to 3: DECconcen 900MX
Attempting connection [^C to abort] ...
Connection Successful!