Owner`s manual

3–22 DEChub 900 MultiSwitch Owner’s Manual
[9] Downline Upgrade (Cont.)
The following events occur after you: (1) select the option, (2) enter the slot number
to be upgraded, enter the load file name, and enter the load host IP address, and (3)
press Return when prompted. Below is an example of the setup port screen display
dialog using a network module with IP services in Hub slot 8.
When both in-band and out-of-band IP addresses are assigned, two network inter-
faces are available to choose from.
When the downline upgrade firmware reads more than one IP address (therefore
more than one network interface), it prompts you to choose a network interface to
use for the load request.
After you press Return, the setup screen displays the following:
Load will be initiated over Hub Slot 8 network interface.
Would you like to use a different interface? Y/[N]:
If you choose the default [N], the setup screen displays the following message:
The device becomes nonfunctional for up to 10 minutes
during the time that the flash load is in progress.
... Press Return Key to Start Load ...
Pressing Return initiates the load over the in-band network interface.
If you choose Y at the screen prompt, the setup screen displays the following:
Interface Description
––––––––– –––––––––––
1 OBM Port
9 Hub Slot 8
Enter the network interface to be used [9]: