Owner`s manual

Enter the hub’s IP address,
then press Return.
The slot you select must contain
a network module that supports
IP services. Refer to Chapter 4
for a list of IP services modules.
3–19Hub Manager
[8] Set In-Band Interface IP Address
Set in-band interface IP address option prompts you for an IP address in the stan-
dard 4–octet dotted decimal notation, in which each octet of the address is repre-
sented as a decimal value, separated by a decimal point (.). If an IP address was
previously configured, an in-band IP address will be displayed. To remove an IP
address, enter Y when this option prompts you to delete your current configuration.
The factory default of this menu option deletes the in-band IP address.
The following is an example of the dialog associated with this option
(user response is shown in boldface type):
Enter selection : 8
DEChub 900 MultiSwitch
IP ADDRESS CONFIGURATION
Format: The standard 4 octet dotted decimal notation in which
each octet of the address is represented as a decimal
value, separated by ’.’ character.
example: 16.20.40.156
To delete the address, enter 0 in the appropriate address
field.
Enter the IP address for In-Band Management : 16.20.54.155
Return
Slot number for In-Band Management (1–8) : 7
Return
Configuring IP address for In-Band Management...
Check ’Show current settings’ from main menu for status.
Press Return for Main Menu ...