Owner`s manual

Selecting Y initiates self-test. At the
completion of self-test, the Hub Status
Display displays the following message:
Selftest Complete
Start Main Firmware
Within a few seconds, the DEChub 900
MultiSwitch installation menu appears
on your setup port screen.
3–13Hub Manager
[2] Reset with Current Settings
Reset with current settings option boots the DEChub 900 MultiSwitch Hub Manager,
but leaves the hub’s configured NVRAM parameters at their current values.
The following is an example of the dialog associated with this option
(user response is shown in boldface type):
Enter selection : 2
DEChub 900 MultiSwitch
RESET WITH CURRENT SETTINGS
This selection will reset your system with the current
configuration settings.
Press Y to confirm [N] : Y
Return
Press Return for Main Menu ...