Owner`s manual

Enter your selection here
and then press Return.
3–11Hub Manager
Hub Setup Port Menu
When the hub setup port is in default mode, the Hub Installation menu appears:
NOTE
The Installation Menu screen displays illustrated in
this manual may vary slightly from the actual
screen displays on your setup port device.
DEChub 900 MultiSwitch
DEChub 900 MultiSwitch INSTALLATION MENU
[1] Reset with Factory Defaults
[2] Reset with Current Settings
[3] Show Current Settings
[4] Set SNMP Read/Write Community
[5] Add SNMP Trap Addresses
[6] Delete SNMP Trap Addresses
[7] Dump Error Log
[8] Set In-Band Interface IP Address
[9] Downline Upgrade
[10] Set Out-of-Band Interface IP Address
[11] Set Out-of-Band Interface Port Speed
[12] Start Event Display Mode
[13] Start Redirect Mode
Enter selection : [nn]
Return
You can exit from any of the menu options and return to the Hub Installation menu by
pressing
Ctrl/C
on the setup port device.