Owner`s manual

3–5Hub Manager
Hub Status Display
The Hub Status Display is a 20-character by 2-line LCD display. The Hub Status Dis-
play continually displays new messages. However, if an event occurs, then the Hub
Status Display pauses with an event notice message, such as when a module is
installed or removed.
Table 3–3 lists the Hub Status Display messages, including event notices, and pro-
vides a description of each message.
Table 3–3: Hub Status Display Messages
Display Message
Description
Hub900MultiSwitch
HW=<rev>, SW=<rev>
This message displays the DEChub 900 Multi-
Switch product name and its current hardware
and software revision level.
Out-of-Band
IP:
This message displays the out-of-band IP
address. The hub OBM IP address is blank
until an address is assigned. Refer to Using
the Hub Setup Port section to configure the
hub OBM IP address.
In-Band
IP:
This message displays the in-band IP address.
The hub in-band IP address is blank until an
address is assigned. Refer to Using the Hub
Setup Port section to configure the hub in-
band IP address.
(continued on next page)