User`s guide

TCP/IP Configuration
5-18
Parameter Description
Internet-Address
The TCP/IP address for the NIC
Netmask
The packet class on the network
Forwarding Reference only. Do not change. Set to N
Base-Port-Number Reference only. Do not change. Set to 1000
Keepalive Reference only. Do not change. Set to Y.
Max-Transmission-Unit Reference only. Do not change. Set to 1500.
Broadcast Reference only. Do not change. Set to 0
SNMP-System-Description Reference only. Do not change. Set to Network Printer
SNMP-System-ID Reference only. Do not change. Set to 1.3.6.1.4.1.24
Ethernet Reference only. Do not change. Set to Y.
Default-Router-IP
Router’s IP address; must be on the same subnet as the NIC’s IP
address. If no network router, keep the default of 0.0.0.0.
Serial-Direction Reference only. Do not change. Set to OUT
Serial-Baud-Rate Reference only. Do not change. Set to 19200
Serial-Data-Bits Reference only. Do not change. Set to 8
Serial-Stop-Bits Reference only. Do not change. Set to 1
Serial-Parity Reference only. Do not change. Set to None
Serial-DTR/DSR Reference only. Do not change. Set to Enabled
Serial-XOn/XOff Reference only. Do not change. Set to Enabled
Novell-Protocol
Enables/disables the IPX protocol.
Use Y to enable or N to disable the protocol.
Apple-Protocol
Enables/disables the EtherTalk protocol.
Use Y to enable or N to disable the protocol.
Banners ON/OFF
Enables/disables the page at the start of each print job. Use On
or Off. This field affects NIC-resident printers. In host-resident
printers, use the -h option or its equivalent.
Parallel-port1-data-format
Serial-port2-data-format
Specifies the lpd filters used by the printer attached to the port.
Reference only. Do not change. Set to PCL PS OTHER.
Do not attempt to disallow data formats by editing this field.
The printer can distinguish data formats (auto-sensing) so there
is no danger of a file being misdirected.
Parallel-port-data-format
Parallel-port-data-format
Reference only. Do not change. Set to UNUSED.
LAT-Protocol
Enables/disables the LAT protocol.
Use Y to enable or N to disable the protocol.
Powerup Status Page
Enables/disables the printer’s Start-Up page.
Use Y to enable or N to disable the page.