User`s guide

TCP/IP Configuration
5-17
###########################################################################
### ###
### NICPRINT.CONF : ###
### ###
### This file contains the configurable parameters to be used when ###
### initiating a communication with the N.I.C. ###
### This file can be altered manually. Remember to leave a tab ###
### between the description and the parameter. ###
### ###
###########################################################################
### ###
### WARNING! ###
### This file includes protocol enable/disable parameters for Novell, ###
### Apple, and DEC LAT. Note that some units cannot support more than ###
### two active protocols in addition to TCP/IP. Ensure that, if you ###
### are configuring such a unit, no more than two of the three ###
### additional protocols are assigned "Y" parameter values. If more ###
### than the allowable number of protocols are enabled, the unit will ###
### revert to the protocols normally enabled on factory default. ###
### ###
###########################################################################
###########################################################################
#Description Parameter
Internet-Address 0.0.0.0
Netmask 255.0.0.0
Forwarding N
Base-Port-Number 10000
Keepalive Y
Max-Transmission-Unit 1500
Broadcast 0
SNMP-System-Description Network printer
SNMP-System-ID 1.3.6.1.4.1.24
Ethernet Y
Default-Router-IP 0.0.0.0
Serial-Direction OUT
Serial-Baud-Rate 19200
Serial-Data-Bits 8
Serial-Stop-Bits-Fixed 1
Serial-Parity None
Serial-DTR/DSR Enabled
Serial-XOn/XOff Enabled
Novell-Protocol Y
Apple-Protocol Y
Banners-ON/OFF OFF
Parallel-port1-data-format PCL PS OTHER
Serial-port2-data-format PCL PS OTHER
Parallel-port-data-format UNUSED
Parallel-port-data-format UNUSED
LAT-Protocol Y
Powerup-Status-Page ON