Specifications

6.2 Optional Equipment Non-Error FIPs
• The Font (PCMCIA) cartridges plug into connectors on the video controller
board. Try moving the cartridge to the opposite slot. See the insert or
remove FIP in Section 6.3
• The Resolution/Graphics Enhancements (RGE) board is socket mounted
on the video controller board. Low resolution image enhancement begins
as soon as the RGE board is plugged in and power is turned on. It cannot
be enabled or disabled. The two high-resolution features (1200 x 600 and
1200 x 1200 dpi) are enabled from the host system or through the Setup
key menu. See Appendix A for more information about the key menus and
Section 1.8 for more information about the RGE.
• The Ethernet network board connects to a socket mounted on the video
controller board.
When power is turned on the Ethernet board’s self-test runs. If the self-test
passes, a status sheet (not shown in this service guide) is printed. On the
status sheet you can find the following:
• The Ethernet address.
• The setting of the twisted pair/ThinWire jumpers.
• Information for the various types of networks.
The rear panel green LED does the following:
If the LED is.. Then..
On steady The self-test is running or has passed.
Flashes briefly The self-test passed, the test sheet is being created, and
printed.
Flashing slowly
continuously
The printer is offline, out of paper, or requires operator
attention. Refer to the front panel display.
Flashing rapidly or
off
Swap the Ethernet board.
6–6 Power and Control Panel FIPs