Specifications

4.9 Adjusting the Leading Edge Registration

Figure 4–8 shows the location of VR202 on the DC control board. VR202

provides a slight amount of registration adjustment. To access VR202 you

must remove the left-side cover and card cage, as shown in Sections 9.19 and

9.16.

The registration adjustment should be checked and adjusted whenever you

replace the following FRUs:

• DC control board

• Paper feed assembly

• Paper feed board

• Scanner assembly

Use the following procedure to adjust the leading edge registration margin:

1. Use a small screwdriver to turn VR202 to the zero (0) position in the center

of its adjustment range. Figure 4–8 shows the location of VR202.

2. Before doing the following step, be ready to mark the leading edge of the

test print.

DSG-000703

Leading Edge of Paper

–

3. Use a suitable tool to press the

test print switch and print a copy

of the engine board test pattern.

See Figure 1–2 for the location of

the test print switch. Print several

copies.

4. Measure the distance (a) between

the image and the edge of the

paper. Find the average of all

measurements.

5. Adjust VR202 until the average measurement is 2 mm (0.079 in).

6. Repeat steps 3 and 4.

7. Readjust VR202 if necessary.

4–10 Test Patterns and Miscellaneous Procedures