Specifications

A.2 Key Menu Messages
Point size= Value
For the values associated with this prompt, see the PCL: Point size entry.
PROTECT= Value
For the values associated with this prompt, see the PS: Page protect entry.
PS: Allow reset
The following value selections determine what happens after
On Line
is
pressed while printing a PostScript job:
• If RESET= Disabled, printing continues until the end-of-job.
• If RESET= Enabled, the user is prompted to press . The job then stops
and the data is lost from memory.
PS: DECimage
The Enable and Adjust values turn on the standard DECimage image
enhancements feature and provide for DECimage parameter adjustment. Do
not confuse this standard DECimage feature with the optional XLI image
enhancement feature.
The following prompts appear when Enable is selected:
ENA= host only
ENA= always
ENA= never
The Adjust value prompts for the following DECimage parameters:
ADJ= normal
ADJ= bright
ADJ= dark
ADJ= hi contrast
ADJ= lo contrast
ADJ= set by host
PS: Page protect
The PROTECT= off, PROTECT= Ltr/A4, and PROTECT= Legal values reserve
memory for a full page bitmap of the PostScript page. Page protect operation
competes for memory with font storage, jam recovery, and the higher resolution
values to significantly slow down the printer, depending on the complexity of
the printing image. For additional information about jam recovery, see the
DEClaser 5100 Printer User’s Guide.
A–14 Key Menu Map, Features, and Values