Specifications

1.2 Physical Description
Table 1–4 Rear View
LocalTalk port This port connector is for connecting to an AppleTalk
network. See Section B.3 for more information.
Parallel (Centronics)
port
Accepts a 36-pin connector cable. The connector is
physically and electronically compatible with the
Centronics protocol.
Serial port This 25-pin connector electronically and electrically
complies with the EIA-232-D or CCITT V.24 interface
specifications.
Fusing assembly
levers
These two levers release the pressure on the fusing
pressure roller. The levers are up when the customer
first receives the DEClaser 5100 or if the fusing unit is
replaced. Operating the printer with one or both of the
levers up, causes fusing failure or paper jams to occur.
Fusing exit/rear
door sensor
This sensor monitors the fusing exit paper path and the
rear door.
Fusing exit The fusing exit opens to allow removal of jammed paper.
Rear door Press the latch to open the rear door to the position
shown. The door opens to allow the user to clear paper
jams.
Power cord
receptacle
Accepts the 115 or 220 Vac power line cord.
DECmultiNET 100e
connectors
These connectors accept standard Ethernet ThinWire
or Thickwire connectors. See Section 1.6 for more
information. If no DECmultiNET option is installed,
a block-off plate can be seen in place of these connectors.
Physical and Functional Description 1–9