Specifications

1.2 Physical Description
Table 1–3 Inside the Top Door
EP-ED connector block The EP-ED connector block is part of the HVPSA
contact guide plate. The block carries the primary,
development, toner sensor, and ground currents to the
EP-ED cartridge. See Section 2.5.1 for more information.
Jam clearance plate Opens to allow removal of jammed paper. Lift the green
handle to open the plate and disengage the upper oblique
rollers.
Transfer roller The foam transfer roller is a crucial part of the
xerographic process. (See Section 2.3.3 for additional
information.) When you handle the transfer roller, only
touch the extreme ends. Fingerprints on the roller can
cause image defects.
Cleaning brush The cleaning brush is used to sweep toner and dust out of
the static eliminator, which is located next to the transfer
roller. The hooked end of the brush is useful for removing
the transfer roller.
Registration sensor This sensor detects paper feeding from any of the
standard or optional feed units. The DEClaser 5100
has no registration clutch or rollers.
Physical and Functional Description 1–7